^ (Project using Beetle board instead of custom PCB)
Custom PCM Eagle files and PDF: https://github.com/hellonun/homemade_hardware/tree/master/slide_pcb
- Do we need to connect GND and VDD on each side of the chip together?
- How much warning is allowed regarding the wire touching (the pins on the chip already has warning)
- What are the 5×2 pads on the sides of the micro USB? Are they to lock the cable? Or should they be connected to something?
NOTE: the 3 headers are to connect to the slide // I tried to model the slide but doing it this way saves space because the USB connector is at the same spot as the pins on the slide
(Maybe I want to make cut-corner edges to make them fitted to the wood/acrylic underneath)
This is the sketch of each layer of the device. The PCB in this case will replace the Beetle board (at the bottom).
Once assembled, the device will look like this